CyberLink PowerDirector Help
Once you have imported all of the media clips into the MultiCam Designer that you want to use in your recording, the next step is to synchronize them.
To synchronize the clips in the MultiCam Designer, do this:
1.Select the Audio source for your recording from the drop-down. You can use the audio of any of the imported video clips or select Imported Audio to use the audio that was imported on to the source audio track.
2.In the Synchronization drop-down, select one of the following:
•Manual: select this option if you want to manually adjust the starting position of each clip on the source tracks. You can do this by clicking and dragging the clips on the source track to a new position.
Note: you can also click the |
button in the camera area to manually move the clip on the source track back one frame. Click 
•Timecodes: select this option and then click Apply if you want the MultiCam Designer to synchronize using the video clip's timecodes. The MultiCam Designer will auto adjust the clips on the source tracks.
Note: this option can only be used if the video clips were recorded with a DV or HDV camera that imprinted the timecode information in the clips and were captured by CyberLink PowerDirector. |
•File Created Time: select this option and then click Apply to use the date and time the file was created as the synchronization points. The MultiCam Designer will auto adjust the clips on the source tracks.
•Audio Analysis: select this option and then click Apply if you want the MultiCam Designer to analyze the audio and then sync the files based on the audio in them. The MultiCam Designer will auto adjust the clips on the source tracks.
•Markers on Clips: select this option and then use the playback controls to find the synchronization points in each clip. Once you find a point, right click on the source track and then select Set Marker. Once you have manually added all the markers, click the Apply button. The MultiCam Designer will adjust the clips on the source tracks.
